- 1 Which Of The Following Does Not Need To Be Considered During The Design Process A Operation Condition B Manufact 1 (118.54 KiB) Viewed 26 times
1. Which of the following does not need to be considered during the design process? (A) Operation condition (B) Manufacture process (C) Component life (D) Safety (E) All of the above need to be considered Answer: 2. Indicate which of the following statements about column buckling is true. (A) Buckling can be ignored when compressive loads are applied. (B) End conditions are irrelevant when calculating the buckling strength. (C) Eccentrically applied loads do not affect buckling strength. (D) Euler buckling is accurate for all slenderness ratios. (E) None of the statements are true. Answer: 3. Which of the following statements is true? (A) Safety factors determined based on stress and strength and design overload are not always equal. (B) The design overload concept is not always valid. (C) Safety factors should always be greater than 4. (D) The reliability of machined parts is always 100%. (E) None of the statements are true. Answer: 4. Which of the following would cause a ductile material to fail in a brittle manner? (A) Large static loads (B) Impact loads (C) Combination of static bending and torsional loads (D) Ductile materials never fail in a brittle manner (E) Combination of static tensile and bending loads Answer: 5. Which of the following statements is true? (A) For impact loading it is customary to ignore stress concentrations. (B) Impact energy absorption capacity is independent of the part volume. (C) Parts subjected to impact must be designed to absorb energy. (D) Impact energy absorption capacity decreases with an increasing in part volume. (E) None of the statements are true.