Page 1 of 1
The figure below shows an example of a simple rig used to test an artisan's welding ability. Artisans are required to we
Posted: Fri Apr 29, 2022 10:04 am
by answerhappygod
- The Figure Below Shows An Example Of A Simple Rig Used To Test An Artisan S Welding Ability Artisans Are Required To We 1 (80.31 KiB) Viewed 28 times
The figure below shows an example of a simple rig used to test an artisan's welding ability. Artisans are required to weld the angle brackets to a plate with welds which must not exceed 3 mm high. The M10x1.5 coarse thread bolt and nut are tightened with 14 Nm of torque. Determine a safety factor for the welds, if any, assuming a weld material with 120 MPa shear strength. 00 20 ܠܠܠܠܠܠܠܠܠܠ 30 50*50*5 "L" 34 M10 30