D2 VDO 4 R1 280 LEO RED D3 R2 200 LED-YELLOW U1 19 RADIANOCTIN 34 RCOT1OSO/T13C RAHAN/C2IN RC1/T1OSICCP28 21 RAZIANZ/CZI

[answerhappygod]

D2 Vdo 4 R1 280 Leo Red D3 R2 200 Led Yellow U1 19 Radianoctin 34 Rcot1oso T13c Rahan C2in Rc1 T1osiccp28 21 Razianz Czi 1 (109.61 KiB) Viewed 26 times

D2 VDO 4 R1 280 LEO RED D3 R2 200 LED-YELLOW U1 19 RADIANOCTIN 34 RCOT1OSO/T13C RAHAN/C2IN RC1/T1OSICCP28 21 RAZIANZ/CZIN. VREF.CVREF RC2CCP1/P1A 30 RASANYCTIN+IVREF. 374 RCUSCK SCL 22 42 RAUTOCKICIOUT 2 RCASOSDA 33 RASANUSSHEVDIN CZOUT RCS SDG RAWOSC2 CLKO RCS/TXICK 44 RATIOSC1/CLKI RCTRXDT 1 9 38 10 RBOJAN12FLTO INTO RDOPSPO RBLANTOINTI RD1PSPI 11 RS2 ANGINTZ 40 12 ROZPSP2 41 12 RBIANS CCP2A 153 RB4 KBIAN11 RDLPSP4 RBS KB/PGM RD5PSPSP18 111 RBSKB2PGC RDOPSP PIC RB7MBISPGO RD7 PSP/PID REORGANS 2 RE1 WRANS / RESSANT 10 REMMERNPP PICT625 D1 ROSPSPS R3 200 LED GREEN VOD 4 PUSH BUTTON 10 0 0 Figure 5: Circuit simulation for Sideroad Traffic Light system Figure 5 shows a circuit simulation for the Sideroad Traffic Light represented with the corresponding LED colors. Initially, the Traffic Light is GREEN. After the stop button is pushed, the YELLOW light will turn on for 10 seconds, and then the Traffic Light will change to RED for 30 seconds. After that, the Traffic Light will return back to GREEN. You are required to design the system using PIC18F4525 microcontroller based on all given conditions. a) Fill in the code snippet below shown in Figure 5 to run the program as required nude ansigned chat 1.1 pose delay tuned charlotte vod for in-0: < > tosOI0Z 3+/-100 void main() in tutta Write the appropriate values for PORT. TRIS, ADCONO, ADCONI and OSCCON for the circuit (OSCCON set internal oscillatorto 4 Mhz with stable output without sleep) wala) while (1) (1) Write the code for tuming the respective color LEDs on and off and the delays needed when push button is pushed for it to operate as designed (0) Write the appropriate values for PORT, TRIS, ADCONO, ADCON1 and OSCCON for the circuit (OSCCON set internal oscillator to 4Mhz with stable output without sleep) (ii) Write the code for turning the respective color LEDs on and off and the delays needed when push button is pushed for it to operate as designed