Page 1 of 1
There is a batch of shaft casting billet parts with diameter ød, which want to drill center holes on both end faces at t
Posted: Wed Apr 27, 2022 8:24 pm
by answerhappygod
- There Is A Batch Of Shaft Casting Billet Parts With Diameter Od Which Want To Drill Center Holes On Both End Faces At T 1 (36.14 KiB) Viewed 42 times
There is a batch of shaft casting billet parts with diameter ød, which want to drill center holes on both end faces at the same time. The workpiece positioning scheme is shown in the figure a-d. Try to calculate the maximum coaxiality error between the center hole and the outer circle. And determine the best positioning scheme. ød.ro 0 (a) (b) (c) (d)