Which two commands can be used to enable LACP when configuring the interfaces for a 40 gigabit etherchannel? (Choose two
Posted: Sat Jul 23, 2022 7:16 pm
Which two commands can be used to enable LACP when configuring the interfaces for a 40 gigabit etherchannel? (Choose two.)
A. switch (config-if)# channel-group 1 mode active
B. switch (config-if)# channel-group 1 mode auto
C. switch (config-if)# channel-group 1 mode desirable
D. switch (config-if)# channel-group 1 mode passive
E. switch (config-if)# channel-group 1 mode LACP
A. switch (config-if)# channel-group 1 mode active
B. switch (config-if)# channel-group 1 mode auto
C. switch (config-if)# channel-group 1 mode desirable
D. switch (config-if)# channel-group 1 mode passive
E. switch (config-if)# channel-group 1 mode LACP