Refer to the exhibit. After setting up an AP to be part of network where WDS is running, you notice that the newly added
Posted: Sat Jul 23, 2022 7:11 pm
Refer to the exhibit.
After setting up an AP to be part of network where WDS is running, you notice that the newly added AP is not able to join the WDS device. On the newly added
AP, you only configure wlccp ap username cisco password ccie. You enable debug radius local-server error to help troubleshoot the issue. Given the debug output, what is the most likely cause of the issue?
A. The WDS device is configured as a local RADIUS and the EAP packets are looping in the network.
B. The WDS device is configured as a local RADIUS and there is a mismatch on the RADIUS shared secret.
C. The newly added AP is configured with a wrong password.
D. The RADIUS server is not reachable.
E. The WDS device is configured for EAP-FAST authentication and the newly added AP is using LEAP.
After setting up an AP to be part of network where WDS is running, you notice that the newly added AP is not able to join the WDS device. On the newly added
AP, you only configure wlccp ap username cisco password ccie. You enable debug radius local-server error to help troubleshoot the issue. Given the debug output, what is the most likely cause of the issue?
- Refer To The Ex 1 (109.44 KiB) Viewed 59 times
B. The WDS device is configured as a local RADIUS and there is a mismatch on the RADIUS shared secret.
C. The newly added AP is configured with a wrong password.
D. The RADIUS server is not reachable.
E. The WDS device is configured for EAP-FAST authentication and the newly added AP is using LEAP.