Refer to the exhibit. All routers are running Cisco IOS software. Which configuration is the minimum needed to correctly
Posted: Sat Jul 23, 2022 7:09 pm
Refer to the exhibit. All routers are running Cisco IOS software. Which configuration is the minimum needed to correctly enable PIM Anycast RP on RP1?
A. ip msdp peer 10.1.1.2 connected-source loopback1ip msdp originator-id loopback 1ip pim rp-address loopback 0
B. ip msdp peer 10.1.1.2 connected-source loopback 0ip msdp originator-id loopback 0ip pim rp-address loopback 0
C. ip pim rp-address loopback0 anycast loopback1
D. ip msdp peer 10.1.1.2ip pim rp-address loopback 0!router bgp 10neighbor 10.1.1.2 remote-as 10neighbor 10.1.1.2 update-source loopback 1
- Refer To The Ex 1 (22.67 KiB) Viewed 63 times
B. ip msdp peer 10.1.1.2 connected-source loopback 0ip msdp originator-id loopback 0ip pim rp-address loopback 0
C. ip pim rp-address loopback0 anycast loopback1
D. ip msdp peer 10.1.1.2ip pim rp-address loopback 0!router bgp 10neighbor 10.1.1.2 remote-as 10neighbor 10.1.1.2 update-source loopback 1