Refer to the exhibit. An administrator must configure a SAN port channel between a Cisco UCS and a MDS switch as shown i
Posted: Sat Jul 23, 2022 7:08 pm
Refer to the exhibit. An administrator must configure a SAN port channel between a Cisco UCS and a MDS switch as shown in the exhibit.
The UCS fabric interconnects are in FC switch mode. The administrator creates a port channel on the MDS switches with the configuration. After performing a "no shut", the interface does not come up.
Which configuration change is needed to bring up the port channel?
A. switchport mode NP on the port-channel interface
B. switchport mode E on the port-channel interface
C. Cisco UCS port configured as storage
D. Cisco UCS port configured as FCoE uplink
E. feature npv configured on MDS
F. feature port-channel configured on MDS
The UCS fabric interconnects are in FC switch mode. The administrator creates a port channel on the MDS switches with the configuration. After performing a "no shut", the interface does not come up.
Which configuration change is needed to bring up the port channel?
- Refer To The Ex 1 (174.52 KiB) Viewed 52 times
B. switchport mode E on the port-channel interface
C. Cisco UCS port configured as storage
D. Cisco UCS port configured as FCoE uplink
E. feature npv configured on MDS
F. feature port-channel configured on MDS