An administrator is replacing a fabric interconnect. The failed fabric interconnect was FI-A and was master at the time
Posted: Sat Jul 23, 2022 7:08 pm
An administrator is replacing a fabric interconnect. The failed fabric interconnect was FI-A and was master at the time of failure. Which process brings the replacement fabric interconnect into the cluster?
A. Connect the new FI-A to the management network and the Layer 1/Layer 2 links to the existing FI-B. Use the Full State Backup file to restore the configuration when prompted at the console.
B. Connect the new FI-A to the management network and the Layer 1/Layer 2 links to the existing FI-B. Let the system sync with FI-B when prompted at the console.
C. Connect the FI-A to the management network and the Layer 1/Layer 2 links to the existing FI-B. Use the All Configuration backup file to restore the configuration through Cisco UCS Manager GUI.
D. Connect the new FI-A to the management network only. Use the Full State Backup file to restore the configuration through Cisco UCS Manager GUI. Connect the Layer 1/Layer 2 cables.
E. Connect the new FI-A to FI-B using the Layer1/Layer 2 cables only. Sync the configuration when prompted. Connect the management interface when the configuration is synced.
A. Connect the new FI-A to the management network and the Layer 1/Layer 2 links to the existing FI-B. Use the Full State Backup file to restore the configuration when prompted at the console.
B. Connect the new FI-A to the management network and the Layer 1/Layer 2 links to the existing FI-B. Let the system sync with FI-B when prompted at the console.
C. Connect the FI-A to the management network and the Layer 1/Layer 2 links to the existing FI-B. Use the All Configuration backup file to restore the configuration through Cisco UCS Manager GUI.
D. Connect the new FI-A to the management network only. Use the Full State Backup file to restore the configuration through Cisco UCS Manager GUI. Connect the Layer 1/Layer 2 cables.
E. Connect the new FI-A to FI-B using the Layer1/Layer 2 cables only. Sync the configuration when prompted. Connect the management interface when the configuration is synced.