When deploying a sensor network that uses CoAP, which of the following must be done on the firewall to allow sensor traf
Posted: Sat Jul 23, 2022 7:08 pm
When deploying a sensor network that uses CoAP, which of the following must be done on the firewall to allow sensor traffic into the data center?
A. Permit UDP traffic from the sensor IP address range.
B. Configure stateful inspection for ROLL.
C. Enable NAT64.
D. Permit IP Option 135 traffic from the sensor IP address range(s).
A. Permit UDP traffic from the sensor IP address range.
B. Configure stateful inspection for ROLL.
C. Enable NAT64.
D. Permit IP Option 135 traffic from the sensor IP address range(s).