A Cisco MDS 9000 Series Switch is configured for SAN Analytics and SAN Telemetry Streaming. An engineer must enable anal
Posted: Fri Jul 22, 2022 7:04 pm
A Cisco MDS 9000 Series Switch is configured for SAN Analytics and SAN Telemetry Streaming. An engineer must enable analytics for NVMe on interfaces in the range of fc1/1-12. Due to a large amount of traffic generated in the SAN environment, the data must be collected at regular intervals of 60 seconds from ports fc1/1-12 and then for ports fc1/13-24 for the next 60 seconds. Ports in the range fc1/13-24 were already enabled for analytics. Which set of commands must be used to meet these requirements?
A.
B.
C.
D.
A.
B.
C.
D.
- A Cisco Mds 900 1 (25.57 KiB) Viewed 56 times
- A Cisco Mds 900 2 (24.14 KiB) Viewed 56 times
- A Cisco Mds 900 3 (18.96 KiB) Viewed 56 times
- A Cisco Mds 900 4 (21.17 KiB) Viewed 56 times