Refer to the exhibit. An engineer reconfigures the port-channel between SW1 and SW2 from an access port to a trunk and
Posted: Fri Jul 22, 2022 7:02 pm
Refer to the exhibit.
An engineer reconfigures the port-channel between SW1 and SW2 from an access port to a trunk and immediately notices this error in SW1's log:
*Mar 1 09:47:22.245: %PM-4-ERR_DISABLE: bpduguard error detected on Gi0/0, putting Gi0/0 in err-disable state
Which command set resolves this error?
A. SW1(config-if)#interface Gi0/0 SW1(config-if)#no spanning-tree bpdufilter SW1(config-if)#shut SW1(config-if)#no shut
B. SW1(config-if)#interface Gi0/0 SW1(config-if)#no spanning-tree bpduguard enable SW1(config-if)#shut SW1(config-if)#no shut
C. SW1(config-if)#interface Gi0/0 SW1(config-if)#spanning-tree bpduguard enable SW1(config-if)#shut SW1(config-if)#no shut
D. SW1(config-if)#interface Gi0/1 SW1(config-if)#spanning-tree bpduguard enable SW1(config-if)#shut SW1(config-if)#no shut
An engineer reconfigures the port-channel between SW1 and SW2 from an access port to a trunk and immediately notices this error in SW1's log:
*Mar 1 09:47:22.245: %PM-4-ERR_DISABLE: bpduguard error detected on Gi0/0, putting Gi0/0 in err-disable state
Which command set resolves this error?
- Refer To The Ex 1 (46.19 KiB) Viewed 60 times
B. SW1(config-if)#interface Gi0/0 SW1(config-if)#no spanning-tree bpduguard enable SW1(config-if)#shut SW1(config-if)#no shut
C. SW1(config-if)#interface Gi0/0 SW1(config-if)#spanning-tree bpduguard enable SW1(config-if)#shut SW1(config-if)#no shut
D. SW1(config-if)#interface Gi0/1 SW1(config-if)#spanning-tree bpduguard enable SW1(config-if)#shut SW1(config-if)#no shut