An engineer wants to configure a zone on the Expressway-E to receive communications from the Expressway-C in order to al
Posted: Fri Jul 22, 2022 7:01 pm
An engineer wants to configure a zone on the Expressway-E to receive communications from the Expressway-C in order to allow inbound and outbound calls.
How is the peer address configured on the Expressway-C when Expressway-E has only one NIC enabled and is using static NAT mode?
A. Expressway-E DHCP
B. Cisco UCM FQDN
C. Cisco UCM DHCP
D. Expressway-E FQDN
How is the peer address configured on the Expressway-C when Expressway-E has only one NIC enabled and is using static NAT mode?
A. Expressway-E DHCP
B. Cisco UCM FQDN
C. Cisco UCM DHCP
D. Expressway-E FQDN