Examine the following partial output of the show run command. The command was executed from Switch A, which is connected
Posted: Fri Jul 22, 2022 3:45 pm
Examine the following partial output of the show run command. The command was executed from Switch A, which is connected to Switch B through both the
Fa0/1 interface and the Fa0/2 interface. Switch A is the root bridge.
Only one of the links is being used. Your intention was to load share the traffic using both links.
What commands do you need to execute to accomplish this? (Choose two.)
A. switchA(config)# interface fa0/2switchA(config-if)#spanning-tree vlan 1-3 port-priority 16
B. switchA(config)# interface fa0/1switchA(config-if)#spanning-tree vlan 4-6 port-priority 16
C. switchA(config)# interface fa0/1switchA(config-if)#spanning-tree vlan 1-3 port-priority 128
D. switchA(config)# interface fa0/2switchA(config-if)#spanning-tree vlan 4-6 port-priority 128
E. switchA(config)# interface fa0/1switchA(config-if)#spanning-tree port-priority 20
F. switchA(config)# interface fa0/2switchA(config-if)#spanning-tree port-priority 20
Fa0/1 interface and the Fa0/2 interface. Switch A is the root bridge.
Only one of the links is being used. Your intention was to load share the traffic using both links.
What commands do you need to execute to accomplish this? (Choose two.)
- Examine The Fol 1 (11.01 KiB) Viewed 56 times
B. switchA(config)# interface fa0/1switchA(config-if)#spanning-tree vlan 4-6 port-priority 16
C. switchA(config)# interface fa0/1switchA(config-if)#spanning-tree vlan 1-3 port-priority 128
D. switchA(config)# interface fa0/2switchA(config-if)#spanning-tree vlan 4-6 port-priority 128
E. switchA(config)# interface fa0/1switchA(config-if)#spanning-tree port-priority 20
F. switchA(config)# interface fa0/2switchA(config-if)#spanning-tree port-priority 20