If device R1 has 1-Gigabit and 10-Gigabit Ethernet interfaces, which command do you enter so that it takes full advantag
Posted: Fri Jul 22, 2022 3:43 pm
If device R1 has 1-Gigabit and 10-Gigabit Ethernet interfaces, which command do you enter so that it takes full advantage of OSPF costs?
A. R1(config-router)#auto-cost reference-bandwidth 10000
B. R1(config-route-map)#set metric 10000000000
C. R1(config-if)#ip ospf cost 10000000000
D. R1(config-route-map)#set metric 10000
E. R1(config-router)#auto-cost reference-bandwidth 10000000000
F. R1(config-if)#ip ospf cost 10000
A. R1(config-router)#auto-cost reference-bandwidth 10000
B. R1(config-route-map)#set metric 10000000000
C. R1(config-if)#ip ospf cost 10000000000
D. R1(config-route-map)#set metric 10000
E. R1(config-router)#auto-cost reference-bandwidth 10000000000
F. R1(config-if)#ip ospf cost 10000