Refer to the exhibit. What commands are needed to add a subinterface to Ethernet0/0 on R1 to allow for VLAN 20, with IP
Posted: Fri Jul 22, 2022 2:48 pm
Refer to the exhibit. What commands are needed to add a subinterface to Ethernet0/0 on R1 to allow for VLAN 20, with IP address 10.20.20.1/24?
A. R1(config)#interface ethernet0/0 R1(config-if)#encapsulation dot1q 20 R1(config-if)#ip address 10.20.20.1 255.255.255.0
B. R1(config)#interface ethernet0/0.20 R1(config-if)#encapsulation dot1q 20 R1(config-if)#ip address 10.20.20.1 255.255.255.0
C. R1(config)#interface ethernet0/0.20 R1(config-if)#ip address 10.20.20.1 255.255.255.0
D. R1(config)#interface ethernet0/0 R1(config-if)#ip address 10.20.20.1 255.255.255.0
- Refer To The Ex 1 (223.96 KiB) Viewed 56 times
B. R1(config)#interface ethernet0/0.20 R1(config-if)#encapsulation dot1q 20 R1(config-if)#ip address 10.20.20.1 255.255.255.0
C. R1(config)#interface ethernet0/0.20 R1(config-if)#ip address 10.20.20.1 255.255.255.0
D. R1(config)#interface ethernet0/0 R1(config-if)#ip address 10.20.20.1 255.255.255.0