Page 1 of 1

Refer to the exhibit. A technician has installed SwitchB and needs to configure it for remote access from the managemen

Posted: Fri Jul 22, 2022 2:34 pm
by answerhappygod
Refer to the exhibit.

A technician has installed SwitchB and needs to configure it for remote access from the management workstation connected to SwitchA.
Which set of commands is required to accomplish this task?
Refer To The Ex 1
Refer To The Ex 1 (54.97 KiB) Viewed 58 times
A. SwitchB(config)# ip default-gateway 192.168.8.254 SwitchB(config)# interface vlan 1 SwitchB(config-if)# ip address 192.168.8.252 255.255.255.0 SwitchB(config-if)# no shutdown
B. SwitchB(config)# ip default-network 192.168.8,254 SwitchB(config)# interface vlan 1 SwitchB(config-if)# ip address 192.168.8.252 255.255.255.0 SwitchB(config-if)# no shutdown
C. SwitchB(config)# interface vlan 1 SwitchB(config-if)# ip address 192.168.8.252 255.255.255.0 SwitchB(config-if )# ip default-gateway 192.168.8.254 255.255.255.0 SwitchB(config-if)# no shutdown
D. SwitchB(config)# ip router 192.168.8.254 255.255.255.0 SwitchB(config-if)# interface FastEthernet 0/1 SwitchB(config-if )# ip default-gateway 192.168.8.254 255.255.255.0 SwitchB(config-if)# no shutdown
E. SwitchB(config-if)# interface FastEthernet 0/1 SwitchB(config-if )# ip default-gateway 192.168.8.252 255.255.255.0 SwitchB(config-if)# no shutdown A