Scenario - An administrator is trying to ping and telnet from Switch to Router with the results shown below: For this
Posted: Fri Jul 22, 2022 2:33 pm
Scenario -
An administrator is trying to ping and telnet from Switch to Router with the results shown below:
For this question we only need to use the show running-config command to answer all the questions below:
Router>enable -
Router#show running-config -
What would be the effect of issuing the command access-group 115 in on the s0/0/1 interface?
A. No host could connect to Router through s0/0/1
B. Telnet and ping would work but routing updates would fail.
C. FTP, FTP-DATA, echo, and www would work but telnet would fail
D. Only traffic from the 10.4.4.0 network would pass through the interface
An administrator is trying to ping and telnet from Switch to Router with the results shown below:
For this question we only need to use the show running-config command to answer all the questions below:
Router>enable -
Router#show running-config -
What would be the effect of issuing the command access-group 115 in on the s0/0/1 interface?
- Scenario An Adm 1 (7.89 KiB) Viewed 53 times
- Scenario An Adm 2 (91.97 KiB) Viewed 53 times
- Scenario An Adm 3 (63.11 KiB) Viewed 53 times
- Scenario An Adm 4 (185.91 KiB) Viewed 53 times
- Scenario An Adm 5 (93.73 KiB) Viewed 53 times
- Scenario An Adm 6 (228.08 KiB) Viewed 53 times
B. Telnet and ping would work but routing updates would fail.
C. FTP, FTP-DATA, echo, and www would work but telnet would fail
D. Only traffic from the 10.4.4.0 network would pass through the interface