Scenario - An administrator is trying to ping and telnet from Switch to Router with the results shown below: For this
Posted: Fri Jul 22, 2022 2:33 pm
Scenario -
An administrator is trying to ping and telnet from Switch to Router with the results shown below:
For this question we only need to use the show running-config command to answer all the questions below:
Router>enable -
Router#show running-config -
Which will fix the issue and allow ONLY ping to work while keeping telnet disabled?
A. Correctly assign an IP address to interface fa0/1
B. Change the ip access-group command on fa0/0 from "in" to "out"
C. Remove access-group 106 in from interface fa0/0 and add access-group 115 in.
D. Remove access-group 102 out from interface s0/0/0 and add access-group 114 in
E. Remove access-group 106 in from interface fa0/0 and add access-group 104 in
An administrator is trying to ping and telnet from Switch to Router with the results shown below:
For this question we only need to use the show running-config command to answer all the questions below:
Router>enable -
Router#show running-config -
Which will fix the issue and allow ONLY ping to work while keeping telnet disabled?
- Scenario An Adm 1 (7.77 KiB) Viewed 51 times
- Scenario An Adm 2 (89.86 KiB) Viewed 51 times
- Scenario An Adm 3 (63.14 KiB) Viewed 51 times
- Scenario An Adm 4 (188.87 KiB) Viewed 51 times
- Scenario An Adm 5 (95.08 KiB) Viewed 51 times
- Scenario An Adm 6 (228.43 KiB) Viewed 51 times
B. Change the ip access-group command on fa0/0 from "in" to "out"
C. Remove access-group 106 in from interface fa0/0 and add access-group 115 in.
D. Remove access-group 102 out from interface s0/0/0 and add access-group 114 in
E. Remove access-group 106 in from interface fa0/0 and add access-group 104 in