After you apply the given configuration to R1, you notice that it failed to enable OSPF. Which action can you take to co
Posted: Fri Jul 22, 2022 2:33 pm
After you apply the given configuration to R1, you notice that it failed to enable OSPF.
Which action can you take to correct the problem?
A. Configure a loopback interface on R1
B. Enable IPv6 unicast routing on R1.
C. Configure an IPv4 address on interface F0/0.
D. Configure an autonomous system number on OSPF.
Which action can you take to correct the problem?
- After You Apply 1 (8.96 KiB) Viewed 53 times
B. Enable IPv6 unicast routing on R1.
C. Configure an IPv4 address on interface F0/0.
D. Configure an autonomous system number on OSPF.