To enable router on a stick on a router subinterface, which two steps must you perform? (Choose two.)
Posted: Fri Jul 22, 2022 12:59 pm
To enable router on a stick on a router subinterface, which two steps must you perform? (Choose two.)
A. Configure an IP route to the VLAN destination network.
B. Configure encapsulation dot1q.
C. Configure a default to route traffic between subinterfaces.
D. Configure full duplex and speed.
E. Configure the subinterface with an IP address.
A. Configure an IP route to the VLAN destination network.
B. Configure encapsulation dot1q.
C. Configure a default to route traffic between subinterfaces.
D. Configure full duplex and speed.
E. Configure the subinterface with an IP address.