To allow or prevent load balancing to network 172.16.3.0/24, which of the following commands could be used in R2? (Choos
Posted: Fri Jul 22, 2022 12:27 pm
To allow or prevent load balancing to network 172.16.3.0/24, which of the following commands could be used in R2? (Choose two.)
A. R2(config-if)#clock rate
B. R2(config-if)#bandwidth
C. R2(config-if)#ip ospf cost
D. R2(config-if)#ip ospf priority
E. R2(config-router)#distance ospf
- To Allow Or Pre 1 (54.38 KiB) Viewed 52 times
B. R2(config-if)#bandwidth
C. R2(config-if)#ip ospf cost
D. R2(config-if)#ip ospf priority
E. R2(config-router)#distance ospf