Refer to the exhibit. When running OSPF, what would cause router A not to form an adjacency with router B?
Posted: Fri Jul 22, 2022 12:27 pm
Refer to the exhibit. When running OSPF, what would cause router A not to form an adjacency with router B?
A. The loopback addresses are on different subnets.
B. The values of the dead timers on the routers are different.
C. Route summarization is enabled on both routers.
D. The process identifier on router A is different than the process identifier on router B.
- Refer To The Ex 1 (33.6 KiB) Viewed 53 times
B. The values of the dead timers on the routers are different.
C. Route summarization is enabled on both routers.
D. The process identifier on router A is different than the process identifier on router B.