After filtering a fw monitor trace by port and IP, a packet is displayed three times; in the i, I, and o inspection poin
Posted: Fri Jul 22, 2022 11:29 am
After filtering a fw monitor trace by port and IP, a packet is displayed three times; in the i, I, and o inspection points, but not in the O inspection point. Which is the likely source of the issue?
A. The packet has been sent out through a VPN tunnel unencrypted.
B. An IPSO ACL has blocked the packet's outbound passage.
C. A SmartDefense module has blocked the packet.
D. It is due to NAT.
A. The packet has been sent out through a VPN tunnel unencrypted.
B. An IPSO ACL has blocked the packet's outbound passage.
C. A SmartDefense module has blocked the packet.
D. It is due to NAT.