Page 1 of 1
For the SLS A model shown, a tensile stress of 8MPa is applied at t=0 and held constant over time (creep test). The init
Posted: Thu Jul 14, 2022 2:45 pm
by answerhappygod
- For The Sls A Model Shown A Tensile Stress Of 8mpa Is Applied At T 0 And Held Constant Over Time Creep Test The Init 1 (73.63 KiB) Viewed 35 times
For the SLS A model shown, a tensile stress of 8MPa is applied at t=0 and held constant over time (creep test). The initial strain is 0.04(4%). What is the value of E1? What is the final value of strain at t=∞ ? What is the value of strain at t=0.5 s ? For the figure shown representing a solid cylinder, draw six stress cubes at points 1 A,2 A, 3 A,1 B,2 B, and 3 B in cross-sectiona A and B and on those cubes draw stress arrows representing the complete state of stress with the correct directions and magnitudes. (you may approximate the magnitude of the transverse shear stress in the x−y plane)