The cause of calling a measurement system adequate because it has P/T ratio lesser than 0.1, is ____________
Posted: Thu Jul 14, 2022 1:54 pm
a) A measurement device should be calibrated in units one-tenth large as the accuracy required in final measurement
b) A measurement device should be calibrated in units one-third large as the accuracy required in final measurement
c) A measurement device should be calibrated in units one-fourth large as the accuracy required in final measurement
d) A measurement device should be calibrated in units three-tenth large as the accuracy required in final measurement
b) A measurement device should be calibrated in units one-third large as the accuracy required in final measurement
c) A measurement device should be calibrated in units one-fourth large as the accuracy required in final measurement
d) A measurement device should be calibrated in units three-tenth large as the accuracy required in final measurement