What must be done to interface TTL to CMOS?
Posted: Thu Jul 14, 2022 12:00 pm
a) A dropping resistor must be used on the CMOS of 12 V supply to reduce it to 5 V for the TTL
b) As long as the CMOS supply voltage is 5 V they can be interfaced (however, the fan-out of the TTL is limited to five CMOS gates)
c) A 5 V zener diode must be placed across the inputs of the TTL gates in order to protect them from the higher output voltages of the CMOS gates
d) A pull-up resistor must be used between the TTL output-CMOS input node and Vcc; the value of RP will depend on the number of CMOS gates connected to the node
b) As long as the CMOS supply voltage is 5 V they can be interfaced (however, the fan-out of the TTL is limited to five CMOS gates)
c) A 5 V zener diode must be placed across the inputs of the TTL gates in order to protect them from the higher output voltages of the CMOS gates
d) A pull-up resistor must be used between the TTL output-CMOS input node and Vcc; the value of RP will depend on the number of CMOS gates connected to the node