Answer Happy

Name Print Reading Activities Part 1 Refer to the drawing (167E102) on the next page and answer the following questions. 1. What is the name of the part? 2 Where is the drawing number located? 3 What is the scale of the drawing? 4. How many individual parts make up the unit? 5. Except as noted, what general tolerances are allowed? A. Decimal B. Fractional C Angular 6. How many plug welds are required? 7. What specifications are given for the plug welds? & What other types of welds are indicated? 9. What type of welding rod is specified? 10. List the subassemblies that make up the com pleted unit Part No. B. C. Unit 17 Plug and So Wilds 233 D Subassembly 11. The overall length of the unit is 12. The total width of the unit is 13. The length of the tongue is, 14. The distance from the base of the end plate to the center line of the bore is 15. The bore diameter is ght Goodheart-Willcox Co. Inc. May not be reproduced or posted to a publicly accessible website
Copyright Goodh RING (WB) 24408 24412 W FDE- TV WV END PLATE, REAR (WA) T- TE PLATE (WG) -10 NOTE USE E6013 WELDING ROD THROUGH OUT DIAL PLUNGER BRACKET (WC)) SLEEVE (WD) 4- TIE PLATE (WHO RING (WB PLATE (WNI NOTE SHOWN ON THIS SHEET SEE WELD SUB-ASSEMBLY DRAWINGS FOR WELDING INFORMATION NOT 6TWO2-END PLATES FRONT & REAR AND RINGS W TWICEL-DIAL PLUNGER BRACKET AND SLEEVE (WC, WOW 167WICK CHANNEL AND PIVOT BRACKET (WWF) PINOT BRACKET AND THE PLATES (NG WHO 67 WORM-DIAL PLUNGER BRACKET AND SLEEVE TO CHANNEL AND (WA) -END PLATE, FRONT 24408 24412 6251 6249 R3- GAGE ET BORING FIXTUR EL WELDING FIXTURE TWELDING FIXTURE SPOT AMELD INTRA TWELDING FIXTURE10416) TOOLS 2496 497 010 1/64 V/2 $2750 CLEANUP TO PROVIDE SEAT FOR BALL BEARING SNAP-RING SQUARE WITH BORE 12490 12405 MATERIAL LIST -167W1024-F, HEADSTOOK SUB-ASSEMBLY -167WICZ-R, HEADSTOCK SUB-ASSEMBLY 1-167WIDZM, HEADSTOCK BASE SUB-ASSEMBLY 1-167WICZ), HEADSTOCK TONGUE CHANNEL (WE) PIVOT BRACKET (WF) TONGUE (WO JOHNSON MACHINERY CO HEADSTOCK, LATHE www 167E102 234 Welding Print Reading