use this to answer for all question parts The specifications for a manifold gasket that installs between two engine part
Posted: Mon Jul 11, 2022 11:48 am
use this to answer for all questionparts
The specifications for a manifold gasket that installsbetween two engine parts calls for a thickness of 2.500 mm ± .012mm. The standard deviation of the process is estimated to be0.02mm.
i. What are the upper and lower specification limits for thisproduct?
a. LSL = 2.492 mm, USL = 2.508 mm
b. LSL = 2.480 mm, USL = 2.520 mm
c LSL = 2.408 mm, USL = 2.502 mm
d. LSL = 2.488 mm, USL = 2.512 mm
e. LSL = 2.496 mm, USL = 2.504 mm
ii. The process is currently operating at a mean thickness of2.50 mm. What is the Cp for this process?
a. 1.667
b. 3.910
c. 0.200
d. 0.867
e. 0.333
iii. If the process mean were to drift from its setting of 2.500mm to a new mean of 2.497. What is the Cpk for this process?
a. 1.917
b. 0.250
c. 0.283
d. 1.219.
e. 0.150
The specifications for a manifold gasket that installsbetween two engine parts calls for a thickness of 2.500 mm ± .012mm. The standard deviation of the process is estimated to be0.02mm.
i. What are the upper and lower specification limits for thisproduct?
a. LSL = 2.492 mm, USL = 2.508 mm
b. LSL = 2.480 mm, USL = 2.520 mm
c LSL = 2.408 mm, USL = 2.502 mm
d. LSL = 2.488 mm, USL = 2.512 mm
e. LSL = 2.496 mm, USL = 2.504 mm
ii. The process is currently operating at a mean thickness of2.50 mm. What is the Cp for this process?
a. 1.667
b. 3.910
c. 0.200
d. 0.867
e. 0.333
iii. If the process mean were to drift from its setting of 2.500mm to a new mean of 2.497. What is the Cpk for this process?
a. 1.917
b. 0.250
c. 0.283
d. 1.219.
e. 0.150