Page 1 of 1
3. Does the ratio in this symbol match BS requirement? 4. One of these concentric circles should show a break. Should th
Posted: Fri Jul 08, 2022 6:29 am
by answerhappygod
- 3 Does The Ratio In This Symbol Match Bs Requirement 4 One Of These Concentric Circles Should Show A Break Should Th 1 (215.52 KiB) Viewed 29 times
3. Does the ratio in this symbol match BS requirement? 4. One of these concentric circles should show a break. Should the break be on the outer or inner circle and why? 5. State the vertical distance between the centreline 5 and the centreline 5/1. 6. Explain this instruction. 7. Give the value of this dimension. 8. State the wall thickness here. 9. State (i) what thread is used here; (ii) what dimension standard is used. 10. Give the value of this dimension. 11. What type of section view is the "SECTION A-A"? Is there an alternative method to show the same information as "SECTION A-A" does? 12. There are non-standard Notes for indicating dimensions in the drawing, give one example.
SECTION A-A 1 7- 8- 5 4 9 K 10 65 20 45 ♡ 35 6 Holes on 85 PC.D. 6Dia.1-6 Pitch it. st 20Dia 3 Pitch 37R --F 65 Dia: -55 Dia SOR 30Dia 20Dia 2Pitch -30Dia: 10 40! 80- H T3 10 F -75 Dia- -50 Dia: -40 Dia: 55 Dia: -20Dia 40Dia 6 Holes on 65PC.D 6Dia.1-6 Pitch 16Dia 2 Pitch 35 BIB 10 25 L-16Dia. 2Pitch 110 -6 60 40 30Dia. 2 3 7 5/1 -10