Page 1 of 1
On an Oscilloscope the channel 1's vertical position or offset control allows you to... Select one: O a. Change the Rang
Posted: Fri Jul 08, 2022 6:22 am
by answerhappygod
- On An Oscilloscope The Channel 1 S Vertical Position Or Offset Control Allows You To Select One O A Change The Rang 1 (13.93 KiB) Viewed 54 times
On an Oscilloscope the channel 1's vertical position or offset control allows you to... Select one: O a. Change the Range or 'Volts/div' used to display channel 1. O b. O c. O d. e. Adjust channel 1's zero volt 'ground' marker and resultant waveform up and down on the Scopes display. Add a DC offset voltage to the circuit under test. Move the entire display of the scope in the vertical direction. Finely tune the thickness of the lines used in channel 1's plot.