Circuit Construction Kit: DC - Virtual Lab - Series Circuit | Parallel Circuit | Ohm's Law - PhET Interactive Simulation
Posted: Wed Jul 06, 2022 11:26 am
Circuit Construction Kit: DC - Virtual Lab - Series Circuit | Parallel Circuit | Ohm's Law - PhET Interactive Simulations (colorado.edu)
Procedure: 1. Setup the circuit with 3 distinguished resistors, ammeter and 50 volts battery as shown below. 2. Close the circuit. What do you observe? 3. Remove one resistor. What do you observe this time? 4. Connect the voltmeter at position A, B and C as shown below. Take note the voltage reading after switching on the circuit. 5. Connect the circuit as shown below and switch it on. Also, take note of the ammeter readings. What do you observe? 6. Dicard the setup. Then setup another circuit as shown below. 7. Close the circuit. What do you observe? 8. Remove one resistor. What do you observe this time? 9. Connect the voltmeter at position A, B and C as shown below. Take note of the voltage reading after switching on the circuit.
9. Connect the voltmeter at position A, B and C as shown below. Take note of the voltage reading after switching on the circuit. 500V 40.00 500 30.00 40.00 10. Connect the circuit as shown below and switch it on. Also, take note of the ammeter readings. What do you observe? 50.00 Voltage Questions A. Comparing the readings of step 5 and 10, what is your own view on the two readings? B. Comparing the readings of step 4 and 9, what can you deduce from the two readings? C. right? Why? Do you think the statement written in the keynote is
Procedure: 1. Setup the circuit with 3 distinguished resistors, ammeter and 50 volts battery as shown below. 2. Close the circuit. What do you observe? 3. Remove one resistor. What do you observe this time? 4. Connect the voltmeter at position A, B and C as shown below. Take note the voltage reading after switching on the circuit. 5. Connect the circuit as shown below and switch it on. Also, take note of the ammeter readings. What do you observe? 6. Dicard the setup. Then setup another circuit as shown below. 7. Close the circuit. What do you observe? 8. Remove one resistor. What do you observe this time? 9. Connect the voltmeter at position A, B and C as shown below. Take note of the voltage reading after switching on the circuit.
9. Connect the voltmeter at position A, B and C as shown below. Take note of the voltage reading after switching on the circuit. 500V 40.00 500 30.00 40.00 10. Connect the circuit as shown below and switch it on. Also, take note of the ammeter readings. What do you observe? 50.00 Voltage Questions A. Comparing the readings of step 5 and 10, what is your own view on the two readings? B. Comparing the readings of step 4 and 9, what can you deduce from the two readings? C. right? Why? Do you think the statement written in the keynote is