LAB REPORT QUESTIONS Each question needs to be answered in a separate paragraph in the results section of your report. B
Posted: Wed Jul 06, 2022 11:26 am
LAB REPORT QUESTIONS Each question needs to be answered in aseparate paragraph in the results section of your report. Beforeyou submit this report, be sure to read the feedback on yourreports that have already been graded.
1. From your analysis of the data, what were the measuredresistances of each of your two resistors? Did the measured valuesagree with manufacturers values for each resistor? Why or why not?The information about the resistor tolerance was provided for areason.
2. For the two resistors wired in series, what was the totalresistance and how closely did it match the expected valuecalculated using the equivalent resistance equation? What do youthink caused any differences between the two values? How did thevoltages in each resistor compare to the power supply voltage? Didthe voltages and currents you measured match the values you expectfrom Ohm’s Law? Remember that you are using the resistance valuesyou just calculated, not the ones printed on the resistors. Youranswer to this question should include some discussion of anydiscrepancies between your measured and expected results, and youranswer to the final question should be more than just “yes” or “no”(ie. be specific about the Ohm’s Law connection or lackthereof).
3. Repeat question 2 for the two resistors wired inparallel.
VOTO V £80'0 V ZSO V +80'0 A 76 7 A 60't A 86 7 A 018'0
1. From your analysis of the data, what were the measuredresistances of each of your two resistors? Did the measured valuesagree with manufacturers values for each resistor? Why or why not?The information about the resistor tolerance was provided for areason.
2. For the two resistors wired in series, what was the totalresistance and how closely did it match the expected valuecalculated using the equivalent resistance equation? What do youthink caused any differences between the two values? How did thevoltages in each resistor compare to the power supply voltage? Didthe voltages and currents you measured match the values you expectfrom Ohm’s Law? Remember that you are using the resistance valuesyou just calculated, not the ones printed on the resistors. Youranswer to this question should include some discussion of anydiscrepancies between your measured and expected results, and youranswer to the final question should be more than just “yes” or “no”(ie. be specific about the Ohm’s Law connection or lackthereof).
3. Repeat question 2 for the two resistors wired inparallel.
- Lab Report Questions Each Question Needs To Be Answered In A Separate Paragraph In The Results Section Of Your Report B 1 (358.4 KiB) Viewed 17 times