Page 1 of 1
3. Multsim or PSpice Simulation: Simulate in Multisim or PSpice the circuit in Fig. 5-1. Set Voo to 10 V and Ro to 1k02.
Posted: Sun Jul 03, 2022 12:11 pm
by answerhappygod
- 3 Multsim Or Pspice Simulation Simulate In Multisim Or Pspice The Circuit In Fig 5 1 Set Voo To 10 V And Ro To 1k02 1 (32.82 KiB) Viewed 19 times
- 3 Multsim Or Pspice Simulation Simulate In Multisim Or Pspice The Circuit In Fig 5 1 Set Voo To 10 V And Ro To 1k02 2 (25.54 KiB) Viewed 19 times
- 3 Multsim Or Pspice Simulation Simulate In Multisim Or Pspice The Circuit In Fig 5 1 Set Voo To 10 V And Ro To 1k02 3 (25.86 KiB) Viewed 19 times
3. Multsim or PSpice Simulation: Simulate in Multisim or PSpice the circuit in Fig. 5-1. Set Voo to 10 V and Ro to 1k02. o Determine the gate bias Vo to set the drain voltage to roughly Voo/2 (5 V). o Determine lp. 9m, and r, of the MOSFET at the operating point above. o Determine the small-signal (AC) gain of the amplifier at the operating point above. Simulate in Multisim or PSpice the circuit in Fig. 5-2. Set VoD = 10V, Ro= RIN = Rs = 1k0, Ro R= 20k, and C₁ C₂ = 20 uF. o Determine the gate bias V, to set the drain voltage to roughly Voo/2. o Determine lp. 9m. and ro of the MOSFET at the operating point above. Does 9mRs >> 1 hold? What is the effective transconductance of the MOSFET with degeneration? o Determine the small-signal (AC) gain of the amplifier at the operating point above.
VG M +₁ RD M₁ VDD Figure 5.1: Measuring small-signal MOSFET parameters
RIN C₁ Vi o MI VG 2 RG VDD WHI Ro M₁ Rs C₂ H MI R₁ -o Vo Figure 5-2: CS MOSFET amplifier with Rs resistor