Answer Happy

Configure DHCPv4
a. Configure DHCPv4 on R3 VLAN 85 withthe addresses specified in the Addressing Table.
i. Configure R3 toexclude the first 50 addresses from the VLAN 85.
ii. Create a DHCP pool namedR3-VLAN85 (case-sensitive).
iii. Configure the DHCP pool toinclude the appropriate network address, the default gateway, andthe IP address of the DNS server.
iv. Configure hosts PC4 to receive IPaddress from a DHCP server.
Configure DHCPv4
a. Configure DHCPv4 on R3 VLAN 85 withthe addresses specified in the Addressing Table.
i. Configure R3 toexclude the first 50 addresses from the VLAN 85.
ii. Create a DHCP pool namedR3-VLAN85 (case-sensitive).
iii. Configure the DHCP pool toinclude the appropriate network address, the default gateway, andthe IP address of the DNS server.
iv. Configure hosts PC4 to receive IPaddress from a DHCP server.
Part 6: Configure EtherChannel
Channel Group
Ports
Protocol
3
D2 G1/0/3, G1/0/4
SWD201 FA0/3, FA0/4
PAgP
5
D2 G1/0/15, G1/0/16
SWD202 G1/0/15, G1/0/16
LACP
a. Add a new 2960 switch SWD201. Add anew 3560 or 3650 switch SWD202.
b. Configure basic switchsettings.
c. Configure and verify anEtherChannel with Cisco PAgP.
d. Configure and verify an 802.3adLACP EtherChannel.
Topology 1 10.1.13.0/24 R1 GO/0/1.1/::1 2001:db8:acad:/64 PC1 G1/0/23 .50/::50 vlan 50 "Group50" G1/0/11 -13/::d1 D1 .1/::1 SO/1/1 Interface vlan 50 10.2.50.1/24 2001:db8:acad:d1/64 Interface vlan 60 10.2.60.1/24 2001:db8:acad:d1/64 G1/0/24 10.1.3.0/24 2001:db8:acad:/64 PC2 .50/::50 vlan 60 "Group60" .3/::3 SO/1/1 Note: D2 is acting as a L2 switch G1/0/23 PC3 .50/::50 vlan 75 "Group75" R3 Interface GO/0/1.75 Supporting dot1q vlan 75 10.3.75.1/24 2001:db8:acad:1/64 Interface GO/0/1.85 Supporting dot1q vlan 85 10.3.85.1/24 G1/0/11 2001:db8:acad:1/64 Interface vlan 75 10.3.75.14/24 2001:db8:acad:d2/64 GO/0/1- G1/0/24 PC4 .50/::50 vlan 85 "Group85"