Answer Happy

Accurate answers. Every time.
https://answerhappy.com/

A bolt is used for a connection where the initial stress on the bolt is 65 MPa. If the bolt is exposed to fully reversed

https://answerhappy.com/viewtopic.php?t=590636

Page 1 of 1

A bolt is used for a connection where the initial stress on the bolt is 65 MPa. If the bolt is exposed to fully reversed

Posted: Fri Jul 01, 2022 6:38 am
by answerhappygod
A Bolt Is Used For A Connection Where The Initial Stress On The Bolt Is 65 Mpa If The Bolt Is Exposed To Fully Reversed 1
A Bolt Is Used For A Connection Where The Initial Stress On The Bolt Is 65 Mpa If The Bolt Is Exposed To Fully Reversed 1 (10.12 KiB) Viewed 29 times
A bolt is used for a connection where the initial stress on the bolt is 65 MPa. If the bolt is exposed to fully reversed loading and the safety factor of the design for fatigue failure is N-3, calculate the alternating and mean stresses on the bolt? (Se-200 MPa, Sut-300 MPa). Solution:
All times are UTC-05:00
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited