Answer Happy

Please create simulation in Pspice and do not copy from anyprevious answers posts. Thank you.
Background This lab will explore the DC characteristics of a MOS transistor. For the SPICE simulations and for the actual circuit, use the model of an n-channel transistor in the CD4007 MOS transistor.
GS μCox W Ox 2 L + Rp VDS M1 Figure 1 VDD SPICE Simulations: 1. Enter the circuit of Figure 1 into SPICE. Do not specify the W and L values of the MOSFET on the schematic; these values are already in the model file. Set VDD = 5V. 2. Run DC Sweep. Sweep VGs from 0 to 5 volts. Obtain a plot of ID as a function of VGS. Also add a trace that is a mathematical expression for the drain current in the forward active region. ID = K(VGS-Vth)² where K = uCox is the SPICE model parameter KP, Vth is the SPICE model parameter VIO, and W and L are the transistor dimensions.) Refer to the model file of the CD4007 n-channel transistor to obtain these parameters.
3. Add a plot showing VGS, VGD, and Vth. To plot VGD, you will need to use a math function of two circuit voltages. To plot Vth, just enter "1.6" as the trace expression. 4. Using vertical lines drawn on the graph, label the three regions of operation: cutoff, forward active, and linear (triode). 5. Change the circuit by removing Rp and replacing it with a wire. Now, VDs= VDD. Assign a DC value of 2V to VGs, and then sweep VDD from 0 to 5V. Obtain a plot of ID. 6. Identify the value of VDs at which the transistor transitions into its saturation (i.e., forward active) region. 7. Find an approximate value for AVDS / AID in each region. 8. In the linear region, find Rps = AVDs/AID and compare it with Rps = [μC (VGS-Vih)] 9. In the saturation region, find ro- AVDS/ AID and compare it with r. AD 10. Put Rp back in the circuit. Repeat the simulation with the bulk terminal of the transistor connected to -1V instead of ground. 11. Run Bias point and find the value of Vth.