Page 1 of 1
In this assignment, using SolidWorks, you have to create the 3D models for the two components shown in Figures 1 and 2.
Posted: Sat Feb 19, 2022 3:31 pm
by answerhappygod
- In This Assignment Using Solidworks You Have To Create The 3d Models For The Two Components Shown In Figures 1 And 2 1 (87.33 KiB) Viewed 86 times
In this assignment, using SolidWorks, you have to create the 3D models for the two components shown in Figures 1 and 2. For each component, prepare the engineering drawing including: (a) three standard views in THIRD ANGLE PROJECTION; (b) an isometric view, (c) a title block. (Dimensioning is not necessary.) Q1. Not to scale 20 10 Figure 1 Q2 Not to scale Hoe -20 CS 30 20 a RS 14 12 Hole 10 Deep Typ Rectangular sox55 Typ FRONT VIEW RIGHT SIDE VIEW Figure 2 Deliverables You have to submit ONE SolidWorks part file (*.sldprt) and ONE SolidWorks drawing file (*.slddrw) FOR EACH
QUESTION. (Gentle reminder: You have to submit totally FOUR files in a compressed file.)