Page 1 of 1
6 m B с 1. With the given Figure 1: P3.1, where bar AB is supported at A with a pin and supported at B with a cable anch
Posted: Sat Feb 19, 2022 3:25 pm
by answerhappygod
- 1 (136.84 KiB) Viewed 53 times
6 m B с 1. With the given Figure 1: P3.1, where bar AB is supported at A with a pin and supported at B with a cable anchored at point C. The bar supports a cylindrical shaft with a mass of X-kg. Determine how heavy should the shaft be assuming that the cable can only support 50MPa with a cross-sectional area of 100mm2. Do not consider the weight of bar AB. - 9 4 m է Figure 1: P3.1 B 3 m 3 m c 70 KN 4 m 2. The given truss system on the figure is loaded with a 40kN load at point A and 70kN load at point C. Running a truss analysis on the said system, Determine the internal forces on members BC, BD, and CF. Determine the stresses experienced by the members assuming the BC, BD, and CF has 1400mm2 of cross- sectional area. D 40 KN 4 m Figure 2: P3.2