PROBLEM 1: Refer to your ID number, look for the last two digits, and add it (e.g., the last digit of your ID number is
Posted: Sat Feb 19, 2022 3:14 pm
- Problem 1 Refer To Your Id Number Look For The Last Two Digits And Add It E G The Last Digit Of Your Id Number Is 1 (94.89 KiB) Viewed 37 times
last digit id no. 28
bolt diameter 30mm
PROBLEM 1: Refer to your ID number, look for the last two digits, and add it (e.g., the last digit of your ID number is 56, 5+6=11). After you add, look for the table for the C-section to be used. Also, look for the last digit of your ID number for the value of "S" to be used. Section Value of "S" Sum of the last 2-digit ID no. 3,9,15 0,6,12,18 4,10,16 5,11,17 1,7,13 2,8,14 Last Digit of ID no. 0,2,5,8,9 1,3,4,6,7 65 50 C15 x 50 C12 x 30 C15 x 40 C12 x 25 C15 x 33.9 C12 x 20.7 The section shown carries a total service tension load of (400 + last 2 digits of your ID number) kN with a dead-to-live-to- wind-to-seismic load ratio of 2:3:1:1. If the tension member has a length of 3 meters and A36 steel, determine the following: a. (30 points) The effective net area b. (2 points) The LRFD design strength C. (2 points) The ASD design strength d. (1 point) is the section adequate? 50 mm iz 750m 011 1 g2 750nm va Izi -50mm-