Answer Happy

4. Use graphical (parallelogram) method to determine the resultant force R Draw a vector sum diagram (with ruler, protractor, compass) on a graph sheet using scaling factor of 0.5 N/cm, i.e., 2 cm for 1 N. (Note: graphic sheets are provided at the end of Exp 4 lab manual). Measure the magnitude R and the orientation angle 0; of the resultant force Ř. Record the magnitudes (R & E) and orientation angles (@j & 0) in the row “Graphic result" of each Table. 5. Use analytical method to determine the resultant force R. • Using component method (Fig. 3) compute the magnitude R and the orientation angle or of the resultant force R. Record the magnitudes (R & E) and orientation angles (0; & 0) in the row “Analytical result" of each Table. . R Table 1 Results of Measurement #1: F1: 200 g at 60.0°; F2: 200 g at 150.0°. F1 (N) F2 (N) R (N) OR ËT (N) Balance Resultant force 2.80 force 0.00 2.06 105 285 Measured result Graphical result Analytical result 2.80 : F2 (N) | F3 Table 2 Results of Measurement #2: F1: 200 g at 30.0°; F2: 200 g at 120.0°; F3: 200 g at 180° FI (N) (N) | | (N) OR El (N) Resultant Balance force force Measured result 2.00 2.00 3.00 115 3.00 2.95 Graphical result 00 2.00 Analytical result 2.00 Table 3 Results of Measurement #3: F1: 200 g at 30.0°; F2: 150 g at 150.0°; F3: 250 g at 180.0° FI (N) F2 (N) F3 (N) TRI (N) OpeĒ (N) Resultant Balance force force Measured result 2.00 1.50 2.80 140 2.80 320 Graphical result 1.50 Analytical result 2.00 1.50 2.50
Lab report on Experiment 4 1. 2. The drawing of the vector sum diagram (Procedures 4) must be included in your Exp 4 lab report. 3. The drawing of the component diagram (Procedures 5) must be included in your Exp 4 lab report. st.
verb