Answer Happy

Reset the PhET simulation (using the button in the lower right)
and set it up in the following manner:
select Oscillate, select No
End, and use the parameters in parentheses by sliding the
bars
for Amplitude (1.00 cmcm), Frequency (1.60 HzHz ), Damping (none),
and Tension (highest). Using the
available Rulers, calculate the frequency of
a photon that corresponds to the wavelength of the resulting wave.
Assume the length with units (cmcm) of the ruler represents the
real photon wavelength and that the speed of light
is 3.00×108 m/s3.00×108 m/s.
Express the frequency in hertz to two significant figures.
<Homework Chapter 08 PhET Simulation - Wave on a String 2 of 5 Reset the PhET simulation (using the button in the lower right) and set it up in the following manner: select Oscillate, select No End, and use the parameters in parentheses by sliding the bars for Amplitude (1.00 cm), Frequency (1.60 Hz), Damping (none), and Tension (highest). Using the available Rulers, calculate the frequency of a photon that corresponds to the wavelength of the resulting wave. Assume the length with units ( cm) of the ruler represents the real photon wavelength and that the speed of light is 3.00 × 108 m/s. Express the frequency in hertz to two significant figures. ► View Available Hint(s) G| ΑΣΦ ? xa Xb √x vx x X.10n X frequency = 6.8.112 ! You have already submitted this answer. Enter a new answer. No credit lost Try again <४ |X| Hz