Page 1 of 1
Question 1 A 150 x 75 x 12 angle shown in Figure 1 is connected to a gusset plate using a E70XX 10mm weld. Using S355JR
Posted: Wed Jun 08, 2022 8:44 am
by answerhappygod
- Question 1 A 150 X 75 X 12 Angle Shown In Figure 1 Is Connected To A Gusset Plate Using A E70xx 10mm Weld Using S355jr 1 (21.82 KiB) Viewed 30 times
Question 1 A 150 x 75 x 12 angle shown in Figure 1 is connected to a gusset plate using a E70XX 10mm weld. Using S355JR steel do the following. 1.1 Calculate the design tensile resistance of the angle. (15) 1.2 If the transverse weld is removed calculate the tensile resistance that will govern the design. (5) Note: Check all possible failure modes 145 mm T 50 mm 280 mm Figure 1: Gusset Plate Connection