Part E OneSteel Section Type E = 250UB37.3 fyE = 285 MPa
Posted: Wed Jun 08, 2022 8:18 am
Part E
OneSteel Section Type E = 250UB37.3
fyE = 285 MPa
Part E - There is 1 question in this part There is a cantilever beam with a vertical point load P acting at L/3 and another vertical point load P acting at 2L/3. Refer to your email from Tim which defined the OneSteel Section Type E and the yield stress fyE. The length of this beam is L, such that the span to depth ratio (L/d) = 9.5, based on your OneSteel beam depth. The beam is loaded so that it bends about the x axis. Before attempting this question, draw a diagram of this beam and the loading (you do not need to submit the diagram, but it will help you). Question 14 2 pts Question E1 What value of P (in kN) will make the beam yield due to bending?
OneSteel Section Type E = 250UB37.3
fyE = 285 MPa
- Part E Onesteel Section Type E 250ub37 3 Fye 285 Mpa 1 (77.88 KiB) Viewed 40 times