A lead screw is pictured and has the average diameter of 40 mm (as seen below). It also has a flat thread (profile angle
Posted: Tue Jun 07, 2022 2:08 pm
A lead screw is pictured and has the average diameter of 40
mm (as seen below). It also has a flat thread (profile angle 2
= 0 °)
with two threaded inputs and a gradient/climb of 24 mm. The
friction number between the screw thread and the thread in
the fixed block is 0.15.
If the torque M = 60 Nm acts on the right part of the screw,
what force F is then required to move the screw to:
a) the left at constant speed?
b) the right at constant speed?
40 12 Alla mått I m
mm (as seen below). It also has a flat thread (profile angle 2
= 0 °)
with two threaded inputs and a gradient/climb of 24 mm. The
friction number between the screw thread and the thread in
the fixed block is 0.15.
If the torque M = 60 Nm acts on the right part of the screw,
what force F is then required to move the screw to:
a) the left at constant speed?
b) the right at constant speed?
- A Lead Screw Is Pictured And Has The Average Diameter Of 40 Mm As Seen Below It Also Has A Flat Thread Profile Angle 1 (68.39 KiB) Viewed 37 times