Page 1 of 1
MENG 317 Instrumentation and Measures An assemblage of a hole and a shaft is designated as shown below. For this assembl
Posted: Sun Jun 05, 2022 9:47 pm
by answerhappygod
- Meng 317 Instrumentation And Measures An Assemblage Of A Hole And A Shaft Is Designated As Shown Below For This Assembl 1 (12.42 KiB) Viewed 44 times
MENG 317 Instrumentation and Measures An assemblage of a hole and a shaft is designated as shown below. For this assemblage, determine the following: +0.25 Hole: 50, +0.00 mm Shaft: 50 +0.05 +0.005 mm (i) The tolerance of the hole. (ii) The tolerance of the shaft. (iii) The fundamental deviations of the hole and shaft.