Answer Happy

*For the circuit shown in Fig.2 answer (11.12 and 13) 11) The current Iin (mA) is: A) 0 B) 1 C) -1 D)-2 E) 2 G) None 12) The voltage V, in volt is: A) 8 B)-4 C) 4 D) 60 E) 16 ) none 13) The power generated by the dependent source 4Vs in (mw) is: A) 16 B)-40 C) 60 D) -600 E)-16 F) 64 G) none **For the circuit in Fig. 3 answer (14, 15. and 16) 14) the Thevenin voltage between (a deb)is: A) 3.878 B) 2.65 C) 6.356 D) -6 E) 5.2 F) none 15) Rain (2) between (a &b) is: A) 1.18k B) 2k C) 1.6k D) 0.848k E)848.48 F) none 16) the maximum possible power (in mwatt )supplied to a load resistor between (a db) is: A) 44.3 B) 4.43 C) 66 D) 46.410 E) 40.79 F) none 2V 2mA 6 km 2k0 V.2km 4103 % MA 30 12 V fig.2 For the circuit in Fig4 use Mesh analysis to answer (17, 18, and 19) B) 0.329 C) -3 D) 2 E) 5 F) None 17) The current I, in (A) is: A)1 18) The current Is in (A) is: A) -1 19) The current I, in (A) is: A) 5 C) -1.025 D) 2 E) 1 F) None B) S B) 3.5 C) 3 D) -3.5 E) 0.162 F) None 20) While checking out a series be. You should look for: D) a high resistor value resistive circuit, you find that the current is higher than it should A) an open circuit B) a short C) a low resistor value F) both choices (B & C) E) both choices (A & D) 21) A sine wave with a frequency of 12 kHz is changing at a faster rate than a sine wave with a frequency of: A) 20 kHz B) 15 kHz C) 30k Hz D) 10,000 Hz E) 1.25 MHz F) None 22) A sine wave with a period of 2 ms is changing at a faster rate than a sine wave with a period of: A) Ims B) 0.0025 s C) 1.5 ms D) 10s E) 100μs F) None www. 1002 6 V 292 www 4102 F) 6 F)-16 {60 100 fig.3 b- 5023 fig.4