The design of the gear-and-shaft system depicted necessitates the use of steel shafts of the same diameter for both AB a
Posted: Fri May 27, 2022 6:36 am
- The Design Of The Gear And Shaft System Depicted Necessitates The Use Of Steel Shafts Of The Same Diameter For Both Ab A 1 (141.57 KiB) Viewed 20 times
The design of the gear-and-shaft system depicted necessitates the use of steel shafts of the same diameter for both AB and CD. It is also necessary that the maximum pressure be 60 MPa, and that the angle D through which the end D of shaft CD turns not exceed 1.5°. Determine the needed shaft diameter using G = 77.2 GPa. (10 Marks) 40 mm T = 1000 N.m 100 mm 400 mm B 600 mm