Need help. Design (Using FluidSim) and construct the pneumatic circuits that satisfies the conditions stated below. Use
Posted: Thu May 26, 2022 10:22 am
Need help.
Design (Using FluidSim) and construct the pneumatic circuits
that satisfies the conditions stated below. Use
ONLY the available components
listed.
• Single Acting Cylinder
• Magnetic Proximity Sensor
• Double Acting Cylinder
• Pressure Sensor
• One-way flow control valve
• Inductive Proximity Sensor
• Pushbutton Module
• Capacitive Proximity Sensor
• Relay Module
• Optical Proximity Sensor
• Relay Module w/ Time Delay
• 3/2-way solenoid valve w/ spring return, normally-closed
• Change-Over Switch w/ roller • 5/2-way solenoid impulse
valve
• 5/2-way solenoid valve w/ spring return
A PICTURE WOULD DO. THANKS
III. Design Parameters: Maintain 4 bars operating pressure in all problems Always use a Magnetic Proximity Sensor to indicate the position of cylinders (min or max stroke only) Always provide the State Diagram profile of each cylinder Circuit operation must be repeatable 1. The control of a bulk material mixing system consists of a push button (S1) and a selector switch/detent (S2). Once the appropriate silo has been selected using the selector switch (S2), pressing the push button (S1) opens the silo. Use 5/2-way directional control valves. Designate two lamps to indicate which cylinder is in operation. For isolation purposes, each cylinder can only extend if the other cylinder is fully extended. 2.0 1.0
Design (Using FluidSim) and construct the pneumatic circuits
that satisfies the conditions stated below. Use
ONLY the available components
listed.
• Single Acting Cylinder
• Magnetic Proximity Sensor
• Double Acting Cylinder
• Pressure Sensor
• One-way flow control valve
• Inductive Proximity Sensor
• Pushbutton Module
• Capacitive Proximity Sensor
• Relay Module
• Optical Proximity Sensor
• Relay Module w/ Time Delay
• 3/2-way solenoid valve w/ spring return, normally-closed
• Change-Over Switch w/ roller • 5/2-way solenoid impulse
valve
• 5/2-way solenoid valve w/ spring return
- Need Help Design Using Fluidsim And Construct The Pneumatic Circuits That Satisfies The Conditions Stated Below Use 1 (138.72 KiB) Viewed 13 times
III. Design Parameters: Maintain 4 bars operating pressure in all problems Always use a Magnetic Proximity Sensor to indicate the position of cylinders (min or max stroke only) Always provide the State Diagram profile of each cylinder Circuit operation must be repeatable 1. The control of a bulk material mixing system consists of a push button (S1) and a selector switch/detent (S2). Once the appropriate silo has been selected using the selector switch (S2), pressing the push button (S1) opens the silo. Use 5/2-way directional control valves. Designate two lamps to indicate which cylinder is in operation. For isolation purposes, each cylinder can only extend if the other cylinder is fully extended. 2.0 1.0