Page 1 of 1
Create a LabVIEW VI that controls motor position using a simple knob on the front panel. You will rotate the knob betwee
Posted: Mon May 23, 2022 10:53 am
by answerhappygod
- Create A Labview Vi That Controls Motor Position Using A Simple Knob On The Front Panel You Will Rotate The Knob Betwee 1 (45.42 KiB) Viewed 11 times
Create a LabVIEW VI that controls motor position using a simple knob on the front panel. You will rotate the knob between 0 and 360 degrees and the motor should snap to the desired angle as quickly as possible with no overshoot. You will use the built-in encoder for feedback, as well as a PID control algorithm which will be explained in class.